How to Drive a Solid Stake Delta with a Peg Hammer

Quick Answer

Use the Steel Head Peg Hammer to drive a Solid Stake Delta at a 45-degree angle, using the wide head for striking and the two-part hook for rope attachment.

Step-by-Step: Using the Solid Stake Delta with the Steel Head Peg Hammer

1. 1. Position the Stake at the Correct Angle: Place the Solid Stake Delta on the ground where you want it, with the wide head facing up and the two-part hook oriented away from your shelter. Tilt the stake so it points toward the shelter at roughly 45 degrees. The stake's shape naturally helps you find this angle. Common mistake: Driving the stake straight down. Always aim for 45 degrees for maximum holding power.
2. 2. Grip the Hammer Safely: Slip the strap of the Steel Head Peg Hammer over your wrist. Grip the wooden handle firmly near the end for maximum leverage. The strap ensures the hammer won't fly off if your hand slips, especially on rocky ground or in wet conditions. Checkpoint: The strap should be snug but not tight against your wrist so you can release the hammer if needed.
3. 3. Drive the Stake with Controlled Strikes: Swing the hammer in a controlled arc, striking the flat, wide head of the Solid Stake Delta. Start with light taps to set the stake, then use full swings as it sinks. Stop when the head is flush with or slightly above the ground—do not bury the head or you'll damage the hook. Common mistake: Overdriving the stake. If the head is below ground, you can't attach the rope and it's hard to remove.
4. 4. Secure the Rope Using the Two-Part Hook: After the stake is fully driven, loop your tent or tarp guyline over the two-part hook on the stake's head. The hook holds the rope securely without slipping, even under tension. Adjust the rope tension as needed. Checkpoint: Ensure the rope is in the hook's notch, not just resting on the stake's head, to prevent it from sliding off.
5. 5. Remove the Stake with the Extended Head: To remove the stake, hook the extended head of the Steel Head Peg Hammer under the stake's wide head. Pull upward or use the hammer's leverage to pop the stake out of the ground. The extended head acts as a dedicated stake puller, making removal easy without bending the stake. Common mistake: Pulling the stake straight up with your hands. Use the hammer's extended head to avoid straining your back or damaging the stake.

Product Details

• Solid Stake Delta: The Solid Stake Delta features a wide and flat head, a two-part hook for easily securing rope after the stake is placed, and a shape that helps to ensure the stake is driven in at the proper 45-degree angle. You don't need to guess the angle; the stake's design guides you to the most secure position for your tent or tarp.

  

• Steel Head Peg Hammer: The Steel Head Peg Hammer is made of forged steel using a historic manufacturing process and features a solid wood handle, a strap for safe hammering, and an extended head for easier stake removal. The strap prevents the hammer from slipping out of your hand, and the extended head acts as a built-in stake puller, saving you from carrying a separate tool.